From 2922a37169da3f6a291d06bae623d724204bafe8 Mon Sep 17 00:00:00 2001 From: distorsion Date: Fri, 24 Jan 2025 23:03:46 +0100 Subject: [PATCH] Commiting an uncomited modification --- Readme.md | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/Readme.md b/Readme.md index 6605396..1213089 100644 --- a/Readme.md +++ b/Readme.md @@ -81,12 +81,12 @@ Everything (_except the separate membrane which is to be printed out of TPU, but Print orientation are quite evident, although we would suggest printing the adapter tube with the flat "top" surface on the bed, and using minimal support to support the two threads meant to hold filters and to support the insuflation mask connector. -For support material, we suggest the following: +Regarding support material ; we suggest the following: - at the bottom of the tube connecting to the insuflation mask - at the bottom of the strap holders - - _optionally_, supporting the threads inside the two cartridge tubes (without support material, some sending might be required) + - _optionally_, supporting the threads ment for connecting the cartridges (_without support material, some sanding might be required_) -We don't recommend having support material under the two tubes for the cartridges, as it is not necessary. We also don't recommend having support material inside the tube connecting to the insuflation mask, as it is not necessary and hard to remove. +We don't recommend having support material under the two tubes for the cartridges, as it is _not necessary and makes the print significantly longer_. We also don't recommend having support material inside the tube connecting to the insuflation mask, as it is _not necessary and hard to remove_. ### 2.b - Supplies : _Other supplies_